PENOSIL
EasySpray izolační pěna pro nástřik

VALUES

• Special formula combined with spray applicator creates a unique foam structure with highly efficient acoustic and thermal insulation and great airtightness properties.

• Spray nozzle allows to insulate uneven or hard to reach surfaces, where it is impossible to use traditional insulation materials.
• The thickness of insulation layer is freely selectable, and the number of layers is not limited.

USAGE INSTRUCTIONS

Put the application nozzle on the tip of the gun. Shake the can vigorously at least 20 times.

Hold the foam can in upright position, turn the gun to the can by holding the gun handle with one hand, and turn the can with the other hand. Make sure that the gun is not pointed at other persons when turning it. The can must not be screwed to the gun with the valve upside down or by turning the gun on the can.

Rotate the nozzle as needed (for vertical or horizontal application).

Turn the can upside down and start applying. Foam output can be adjusted by the gun trigger.

Apply the foam from distance of approx. 40 cm from the surface.

The application distance determines the width of the application area – the shorter the distance, the narrower the application area.

TIPS

• The thickness of the foam in one layer should usually not exceed 2 cm. Please consider, that foam expands twice of what is sprayed out. Next layer of foam can be applied after 60 minutes, if needed.
• Number of layers is not limited.
• At low temperatures the foam can must be warmed before work. The temperature of the warming room or water must not exceed +30°C.
• Air temperature during application +10°C to +30°C, best results at +20°C.
• Can temperature during application +18°C to +28°C, best results at +20°C.
• The surfaces must be clean from dust, loose particles and oil.

LIMITATIONS

• Cured foam is less sensitive to UV-light and direct sunlight than other conventional one-component polyurethane foams. It is still recommended to cover the cured foam with suitable opaque sealant, filler, paint or other material to ensure lasting quality features.
• Do not use in places with long-lasting direct contact with water as this reduces thermal insulation properties.