PENOSIL
Premium Polystyrol FixFoam 877 foam adhesive for insulation boards

VALUES

• Very good gluing and sealing properties.
• Adheres well to various materials incl. polystyrene and mineral substrates.
• Easier, faster, cleaner and cheaper compared to the use of traditional adhesive mortars.
• Strong even structure.

• Sufficient elasticy.
• High quality result under various weather conditions.
• Low post-expansion allows fast and accurate adhesion.
• Application with foam gun.

USAGE INSTRUCTIONS

Hold the foam can in upright position and turn the gun side by holding the gun handle with one hand and turn the can with the other hand. Make sure that the gun is not pointed to other persons when turning it.

The can must not be screwed to the gun with the valve upside down or by turning the gun on the can. After fixing the gun, shake the can well at least 20 times and turn into application position.

The foam output can be adjusted by gun trigger.

Apply the foam adhesive to insulation boards as an even flow, parallel with the sides of the insulation board (3-4 cm from the edge) and one stripe in the middle, parallel to the longest side (up to 25 cm between adhesive stripes).

After applying the foam adhesive to the insulation board wait ~2 min and then press the board to the wall. The level of installed foam polystyrene boards can be adjusted within up to 5 minutes.

Use fastening equipment for balconies, ceilings or long spans.

A moistened substrate ensures faster curing and better result.

TIPS

• Air temperature during application -5 °C to +30 °C, best results at +20 °C.
• Can temperature during application +5 °C to +25 °C, best results at +20 °C.
• Yield considerably depends on working conditions – temperature, air humidity, expansion room.
• The surfaces must be clean from dust, loose particles and oil.
• Cured foam can be painted with water-based paints.

LIMITATIONS

• Foam adhesive does not stick to Teflon, polyethylene or silicone surfaces.
• The cured foam adhesive is sensitive to UV and sunlight and needs to be coated with a suitable opaque material.