PENOSIL
Zasklívací silikon Okna & Dveře odolný vůči povětrnostním vlivům

VALUES

• Cures fast.
• Forms an extremely tough, yet flexible surface.
• Adheres well to wide range of materials and surfaces.

• Maintains flexibility, even when exposed to vibration or structural expansion and contraction.
• Maintains seal quality despite rain, wind, UV radiation and freezing-unfreezing.

USAGE INSTRUCTIONS

Cut off the threaded end of the cartridge and screw on the application nozzle for directing the silicone.

Cut the threaded end under an angle of 45° in a way where a suitable opening for application is produced.

Place the cartridge together with the applicator in the gun and fill the installation nozzle with silicone by repeatedly pressing the gun trigger.

Apply silicone in the joint by repeatedly and evenly pressing on gun trigger and smoothly dragging the nozzle continuously along the joint. After application of the silicone, smooth it with a rubber silicone scraper and remove the excess material.

TIPS

• Surfaces must be clean, dry, and free from dust, grease and other contaminants, which may affect the adhesion.
• Non-porous surfaces (such as aluminium, glass, etc.) should be cleaned with a suitable solvent.
• Porous substrates (such as concrete, brickwork, etc.) must be mechanically cleaned to remove loose particles.
• The surface to be covered must be dry.
• Ensure adequate ventilation in all joint locations.
• During the curing process, make sure that no impurities can settle on the surface and that the joint surface is not affected by mechanical load.
• Do not use at temperatures below +5 °C.

LIMITATIONS

• Does not adhere to polyethylene (PE), polypropylene (PP), PTFE (Teflon®), neoprene rubber and bitumen surfaces.
• Not recommended to use on natural stones, such as: marble, granite, etc.
• Due to the wide variety of possible substrates, we recommend a preliminary compatibility test.