PENOSIL
Premium Sanitary Silicone

VALUES

• Excellent processing and smoothing properties.
• Contains fungicides.
• Mould, UV, moisture and weather resistant.
• Allows long working periods.
• Non-sagging, does not spread in the joint.

• Adheres well to glass, glazed surfaces, ceramic tiles, many plastics, metals, and most paints.
• Permanently elastic.
• Long storage time.
• Does not lose volume during the curing process.

USAGE INSTRUCTIONS

310 ml cartridge:

Cut off the threaded end of the cartridge and screw on the application nozzle for directing the silicone.

Cut the threaded end under an angle of 45° in a way where a suitable opening for application is produced.

Place the cartridge together with the applicator in the gun and fill the installation nozzle with silicone by repeatedly pressing the gun trigger.

Apply silicone in the joint by repeatedly and evenly pressing on gun trigger and smoothly dragging the nozzle continuously along the joint.

After application of the silicone, smooth it with a rubber silicone scraper and remove the excess material.

600 ml foil package:

Open the application nozzle of the gun, insert the package in the gun and open on the applicator side by removing the fastening clamp.

Place the applicator nozzle on the opened end and screw on the cap.

Apply silicone in the joint by repeatedly and evenly pressing on gun trigger and smoothly dragging the nozzle along the joint.

After application, smooth the silicone surface with a rubber silicone scraper and remove the excess material.

Sanitary Sealing Manual

TIPS

• The surfaces must be clean from fat, oil, dust and loose particles.
• The surface to be covered must be dry. Ensure adequate ventilation in all joint locations.
• During the curing process, make sure that no impurities can settle on the surface and that the joint surface is not affected by mechanical load.
• Do not use at temperatures below +5 °C. Usage temperature between +5 °C and +40 °C.
• The surfaces must be clean from dust, loose particles and oil.
• Non-porous surfaces should be cleaned with solvent and a clean, non-fluffy cotton cloth.
• Solvent rests should be removed before evaporating with a clean cloth.

LIMITATIONS

• Do not use in contact with natural stones, such as marble and granite.
• Do not use in contact with fibre cement, plaster or mortar.
• Do not use in contact with metals, such as: lead, copper, brass and zinc.
• Do not use in contact with pre-strained polyacrylate or polycarbonate parts as they might be cracked.
• Do not use for sealing aquariums and underwater joints.
• Does not adhere to polycarbonates (layered and corrugated plastics) or Plexiglas (PMMA).
• Cannot be painted.